Step 1 :
Before hemming or welding, leave 30-40mm wide overlap edge for
connection the two disjunct surface pieces, immobilize both ends of
each disjunct pieces with something such as stick belt or clamp.
Step 2 :
Turn on the power, according to quality and thickness of the PVC
banner, consider the ground circumstance, set the proper
termperature and speed, adjust the suitable hot-air blowing rate,
wait for machine hot up around 2 minutes.
Step 3 :
Bring up the machine, place the rubber wheel at the end of the
overlap edge.
Step 4 :
Turn the handle to left down, insert the welder nozzle into the gap
of two overlap pieces, then the machine will moving and seaming
automatic.
Step 5 :
During welding, use the gripe to align the moving direction, let
the upper piece edge be in touch with the inner side of the welder
nozzle.
Step 6 :
After the machine go pass the overlap edge to the end, the two
disjunct pieces will be joined together, then turn the welder
handle to right, it will stop moving.
Step 7 :
Turn off the heater switch, wait the gun come to cold, then turn
off the power supply is ok.
Step 8 :
Notice: To prolong the electrothermal heater, after work it is
strongly advice that cooling the heater at first, then turn off the
power 5 minutes later. In case of the power suddenly be off, should
handle the welding gun away firstly, and close down the temperature
knob, nextly consider the problem of power supply.
Step 9 :
To get better satisfied bonding effect, the ground of the overlap
pieces should be smoothly, hard and heat resistive. We suggest that
the operator may do some more test and practice using some samples
of the pieces to get the suitable speed and temperature and hot-air
blowing rate before operate it for seaming formally.
We assure you :
With good quality product
Offer the best price
Arrange the fast delivery
Provide good after-sales service
Any questions or demand please send your Inquiry Details at the
below , Thanks !
